1 Less wiring controller on-board 2 Simple installation plug-and-play 3 One of the five bright LED color options (Red / Green / Orange / Blue / White) per gauge for four configurable types of fuel (E85, Diesel, Gasoline and Methanol) and lambda display 4 - Sweeping LED "needle" indicator from rich (green) then normal (orange) to lean (red) 5 - Fail safe LOCKED connector - it is not possible to make a wrong connection 6 - Anti-glare faceplate - Non-destructable polycarbonate. Additional faces are paid extra. 7 - Multiple outputs for digital (to PC), analog (to data logger / EMS), narrowband for simulation and extra switch options 8 - On-Gauge Programming Button - No need a PC or tablet for programming upper/lower limits and other settings. 1 Analog 0-5V (9=19 AFR) linear output for engine management systems (EMS) and data loggers (MegaSquirt) 2 Digital output is 9600 8N1 serial that can be connected to your PC 3 Simulated NB output.
WB D2 has a 4ft output cable (5 cables / green-white-red-brown-black) Red power cable goes to 12V source in your vehicle. Black cable goes to a grounded source such as battery ground (-) post.
Green digital output is 9600 8N1 serial that can be connected to your PC. If you want to connect other devices such as data loggers or AFR gauges, you can use white analog cable for 0-5V output.Brown narrowband cable is for simulated NB. The sensor cable (8ft) should be routed in a way so that there would not be any contact with the exhaust piping and other extreme heat sources to prevent damage to the wiring. GUIDELINE FOR THE LOCATION OF THE OXYGEN SENSOR. Weld the bung at least 24 downstream of exhaust port outlet or 24 after the turbocharger. It should always be before the Catalytic Converter. Also it should be before the X or H pipe if there is. Please check your vehicle for exhaust leaks, camshaft overlap and open exhausts because those would cause false lean readings. Not following these directions may result in premature failure of the sensor. D2 gauge assembly, pre-assembled output and oxygen sensor cables with connectors and Bosch LSU4.2 (part# 17014).
D2 assembly includes anti-glare faceplate, black bezel, bung and LED display. APSX WIDEBAND shall not be liable for direct, special, incidental, or consequential damages resulting from any legal theory including, but not limited to, lost profits, downtime, goodwill, damage, injury to persons, or replacement of equipment and property due to improper installation, integration and/or misuse of any APSX WIDEBANDs product(s). APSX WIDEBAND does not guarantee the product functionality with any ECU, data logger or other devices that uses the output signals. Implementation and integration of the product with any other device(s) must be done at your own risk. Improper installation and usage may lead to engine damage.Mount and install the product in a location where it does not obstruct the drivers view and/or ability to safely control the vehicle. APSX D2 Wideband (Black - Red). APSX D2 Digital Wideband O2 Air Fuel Ratio Controller Gauge Kit (Black-Red). APSX D2 has a 4ft output cable (5 cables / green-white-red-brown-black) Red power cable goes to 12V source in your vehicle. The item "WB D2 Digital Wideband O2 Air Fuel Ratio Controller Gauge Kit (Black-Red)" is in sale since Friday, June 3, 2016.
This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Gauges\Other". The seller is "wb-wideband" and is located in Cincinnati, Ohio. This item can be shipped worldwide.